Conecta Hinge Kits with recessed front fixing holders.
Door overlay on hinged side is between 12.5mm and 16mm.
Kit contains:
2 x Conecta Hinges
2 x Conecta Recessed Front Fix Holders (DQGB3) &...
Hinge cover kits for the Conecta and centre hinges.
Kit contains:
2 x Covers for Conecta hinge
2 x Large cover for centre hinge
2 x Small cover for centre hinge
Available in two finishes:
Nickel...
Series M Hinge Kits for the Folder 180 system
Door overlay on hinged side:
18mm with 0mm mount plate
12mm with 6mm mount plate
Kit contains:
2 x Series M Hinges
2 x 0mm inline mount plates
2 x 6...
A sprung hinge with a low profile arm for use on built-in fridge/freezer units or similar integrated appliances with side-hinged doors.
This should be used with 0mm Steel High Mount Plates which ...
A pair of grey plastic rear extension spacer clips.
These reduce the effective runner length by 50mm allowing a near 'full extension' effect for a fraction of the cost of a triple part full exte...
Please note that this synchroniser bar will only work with Salice drawer runners marked 65577 or that have a tab on the runner to receive the synchroniser.
The synchronisation system for Push-open ...
Circular shaped cover caps provide a clean, elegant finish to your glass doors, hiding away the hinge mechanism.
Injection moulded plastic with plated or painted effect metallic finishes.
Diameter...
Screw cover cap for the hinge flange.
This will only suit Series 100, 200, 700, 800 and 900 standard angle hinges, for wide angle hinges, please order this part here.
Please note that it will not s...
A diecast straight 'DOMI' Mount Plate for use with standard wood screws (3.5 x 16mm), finished in Nickel.
Front screw hole to be drilled 21mm from edge of carcase.
0mm height
Typically used on ...
A fully adjustable grey plastic housing for DPM Series PUSH magnetic catches.
Requires 3.0mm countersunk woodscrews for fixing (not supplied)
A seperate metal trim cap S2BX83H9 is required.
A diecast housing for SMOVE system soft-close buffers.
Front lip for carcase edge location.
10mm dia bore allows buffer to be firmly held in place by push-fit intallation.
Drilled for 3.5 x 16mm...
A press-on decorative trim cap for SALICE hinge arms and some cupboard catch housings. This will fit the arms on wide angle hinges.
Available in two finishes:
Nickel - S2BX83H9
Titanium - S2BX8...
